Product ID:SURE-GLIDE INTERIOR LATEX SEMI GLOSS, 25000/25 SERIES
MSDS Date:12/15/1993
FSC:8010
NIIN:00N071257
MSDS Number: CBNLK

MCCORMICK PAINTS

2355 LEWIS AVE
ROCKVILLE, MD 20851
US

Emergency Phone: 800-424-9300 (CHEMTREC)

Info Phone: 301-770-3235

Cage: 0EKH6

MCCORMICK PAINTS

ROCKVILLE, MD 20851 US

Telephone: 301-770-3235

Cage: 0EKH6

0.05.

CAS: 107-21-1

RTECS: KW2975000

Fraction By Weight: <5%

OSHA PEL N/K

ACGIH TLV: 50 PPM, VAPOR, C

EPA Report Quantity: 1 LB

DOT Report Quantity: 1 LB

LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES Skin:YES Ingestion:NO
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:INHALATION:VAPORS OR SPRAY MISTS MAY
BE IRRITATING TO EYE, NOSE, THROAT AND MUCOUS MEMBRANES OF THE
RESPIRATORY TRACT PRODUCING SYMPTOMS OF HEADACHE AND/OR NAUSEA IN
POORLY VENTILATED AREAS.
Explanation of Carcinogenicity:NOT RELEVANT
Effects of Overexposure:SEE HEALTH HAZARDS.
Medical Cond Aggravated by Exposure:SKIN:PROLONGED OR REPEATED CONTACT
W/COATING MAY CAUSE IRRITATION. EYE:DIRECT CONTACT WILL CAUSE
IRRITATION.

First Aid:INHAL:REMOVE TO FRESH AIR. SUPPORT BREATHING (GIVE O*2/ARTF
RESP) . SKIN:WASH THOROUGHLY W/SOAP & WATER. EYES:IMMEDIATELY FLUSH
W/PLENTY OF WATER FOR AT LEAST 15 MINUTES; CONSULT MD. INGEST:IF V
ICTIM IS CONSCIOUS, GIVE TWO GLASSES OFWATER AND CALL MD.

Extinguishing Media:WATER FOG.
Fire Fighting Procedures:USE NIOSH/MSHA APPROVED SCBA & FULL PROTECTIVE
EQUIPMENT .
Unusual Fire/Explosion Hazard:NONE.

Spill Release Procedures:CONTAIN SPILL & REMOVE W/INERT MATERIAL (SAND,
EARTH, ABSORBENT). KEEP SPILL OUT OF SEWERS & OPEN BODIES OF WATER.
KEEP UNNECESSARY PEOPLE AWAY, AS FLOOR MAY BE SLIPPERY.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

Handling and Storage Precautions:STORE ABOVE 34F & BELOW 140F. DO NOT
TAKE INTERNALLY.
Other Precautions:THIS COATING CONTAINS MATERIALS CLASSIFIED AS
NUISANCE PARTICULATES, FOR EXAMPLE TITANIUM DIOXIDE, CALCIUM
CARBONATE, ETC, WHICH MAY BE PRESENT AT HAZARDOUS LEVELS ONLY
DURING SPRAYING THIS COATING OR SANDING OR ABRADING OF THE DRIED
FILM.

Respiratory Protection:NONE REQUIRED IF GOOD VENTILATION IS MAINTAINED
EXCEPT IF PRODUCT IS SPRAYED, THEN USE NIOSH/MSHA APPROVED MASK. IF
TLV IS EXCEEDED THEN USE CANNISTER OR AIR HOSE MASK.
Ventilation:MECHANICAL-LOCAL EXHAUST AT POINT OF CONTAMINANT RELEASE
(VAPOR, MIST OR DUST).
Protective Gloves:IMPERVIOUS GLOVES.
Eye Protection:ANSI APPROVED CHEM WORKERS GOGGS .
Other Protective Equipment:EYE WASH FOUNTAIN & DELUGE SHOWER WHICH MEET
ANSI DESIGN CRITERIA .
Work Hygienic Practices:WASH HANDS BEFORE EATING OR USING BATHROOM.
Supplemental Safety and Health
NONE SPECIFIED BY MANUFACTURER.

Boiling Pt:B.P. Text:212F,100C
Vapor Pres:SEE ING 1
Vapor Density:LTR/AIR
Spec Gravity:1.2
Evaporation Rate & Reference:SLOWER THAN ETHER
Appearance and Odor:NONE SPECIFIED BY MANUFACTURER.
Percent Volatiles by Volume:67

Stability Indicator/Materials to Avoid:YES
ANY MATERIAL THAT REACTS VIOLENTLY W/WATER.
Stability Condition to Avoid:FREEZING OR TEMPERATURE OVER 140F.
Hazardous Decomposition Products:ACETIC ACID, CO AND CO*2.

Waste Disposal Methods:DISPOSE OF I/A/W LOCAL, STATE & FEDERAL
REGULATIONS.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.